VW Rabbit Pickup tailgate logo reproduction

After a ton of trial-and-error, the Rabbit Pickup/ Caddy tailgate logo letters are finally done.

These are also made of Oracal 751.  I’d suggest putting them on in groups of 2 letters at a time.  After cutting a test sticker, installing it, noting where it needed to change, then re-cutting, I was able to get a 1 piece install on my tailgate that looked and fit great.   There must be some differences in the stamping on these, though, because it missed the mark on a different tailgate.  YMMV.  Chop ’em up and install them slowly.

In this pic, they’re applied over the original cracky ones – by applying them 2 letters at a time, I was able to get good results.  It’s better if you just get rid of the cracked ones, obviously.

This happened while peeling off a test set that was cut from some scrap orange vinyl.  I can see people wanting this.

 

 

12 thoughts on “VW Rabbit Pickup tailgate logo reproduction”

    1. Sure, I can get these out to you. They’re $35 shipped in the continental US.
      I’ll send you an email with my paypal address.
      -Chris

  1. Hello , any chance you can sell me 81 caddy tailgate decals in RED? That is the theme I am doing on my restoration .
    Ansel in Eureka.

Leave a Reply to Abraham Rodríguez Cancel reply

Your email address will not be published. Required fields are marked *